Home > Brewing Equipment and Accessories >

Brew-Boss Pro Accessory Port Mounted CIP Ball
Brew-Boss Pro Accessory Port Mounted CIP Ball


 
Alternative Views:


Price: $80.00

Availability:: Usually Ships in 3 to 5 Business Days
Product Code: BBPRO-CIP
Qty:

Description
 

Brew-Boss Pro Accessory Port Mounted CIP Ball


This CIP ball assembly is flow matched to the Chugger Max pump supplied with the Brew-Boss Pro systems. It attaches directly to the accessory port on the Brew-Boss 54 gallon Pro kettle. It allows you to clean your kettle after a brew session very easily.

Cleaning Process for the Brew-Boss pro System:

1. Pump all wort into your fermenter until the pickup tube in the kettle can no longer suck liquid.
2. Use a wet/dry shop vacuum to clean the trub (debris) at the bottom of the kettle.
3. Spray the inside of the kettle with a hose fitted with a spray nozzle to remove as much debris as possible from the heating elements first then from the sides of the kettle.
4. Once you accumulate 3-4 gallons of water, pump the dirty water out of the kettle into a drain or gravity drain the kettle.
5. Using the hose with spray nozzle again, spray the inside of the kettle, heating elements first, until the water level is 2 inches or so above the top heating element.
6. Turn on the heaters to 100% power.
7. Install the Brew-Boss Pro Accessory Mounted CIP Ball to the accessory port.
8. Wait for the water to get quite hot (130-150F), and turn off the heater.
9. Add appropriate amount of PBW (powdered Brewery Wash) or other cleaner to the water.
10. Place the cover on the kettle and make certain the valves are wide open.
11. Turn on the pump. The CIP ball should begin spinning inside the kettle and spraying water all over the inside.
12. Let the pump run for 5-10 minutes or until no debris is visible inside the kettle.
13. Pump the dirty water out of the kettle into a drain or gravity drain the kettle.
14. Using the hose with spray nozzle again, spray the inside of the kettle to rinse the cleaner out of the kettle.
15. Pump the rinse water out of the kettle into a drain or gravity drain the kettle.

The above process seems complex only in the number of steps, but it is basically doing the same few steps over and over. The benefit of this method is the kettle never needs to be lifted or tipped over and no manual scrubbing is necessary.


Note: This item requires a powerful brew pump like the Chugger MAX. It will not operate properly with the standard homebrew style Chugger or TopsFlo pumps we sell.