We are sold out of the Robobrew. The manufacturer is back-ordered and we have a large order placed with them. We were originally told that we'd have our shipment in early October, but have been subsequently notified we won't be receiving them until mid to late December. Sorry for the inconvenience. If you order now you will be placing a Pre-Order and we'll ship as soon as we receive our shipment.
Brew-Boss is the pinnacle electric brewing system for those discerning customers that want the very best. For those on a tighter budget or for those that want a 120 volt system, we now offer the Robobrew system.
The Robobrew is an all-in-one electric brewing system that has built in
elements for heating and boiling, a built in pump for recirculation, an
onboard water resistant control panel for setting and monitoring
temperatures, a removable grain basket, and a built in spigot for
transfering. It is extremely portable and uses 110v power so it can be
used nearly anywhere.
Built in magnetic drive pump to easily recirculate the wort during the
mash. We recommend getting some silicone tubing to go with the
recirculation arm. This allows you more control over the recirculation
and you can then use the pump to transfer your wort to your fermenter.
Dual heating elements run off of a single 110 volt plug and have
individual switches allowing for more control over the heating process.
One element is 1000 watts and the other is 500 for a combined 1500
watts! Use both when you need to ramp up the temperature quickly either
at the start to get to your mash temp or to go from your mash temp to
boiling. Use only one of the elements when you want to hold a
The digital control panel makes it easy to see the current temperature
and set the temperature you want. You can also set a delayed start of up
to 23 hours in advance so that you can have your water hot and ready to
go when you get home from work or get up in the morning. The digital
controller is also water resistant so don't worry about spills or some
water dripping down the side. This controller is built for brewing!
The brewery also includes a stainless steel malt pipe with false bottom
allowing you to easily shift from mash tun to boil kettle during your
brew day. The malt pipe includes a handle to lift it from the RoboBrew
and tabs at the base so you can set the malt pipe over the RoboBrew to
let the wort drain out. It also has feet at its base to raise the malt
pipe slightly off the base and help prevent clogging.
The included stainless wort chillers is shipped with bare ends so you
can set it up for your situation. We list below the most common tubing
and fittings sold to help connect to a hose, hose bib, or faucet.
Note: The manual references an element for a different market.
This unit comes with a two heating elements for a total of 1,500 watts.
Stainless steel construction
9 gallon total capacity with a finished beer output of 5-6 gallons
Digital temperature controller
110v power and plug
Dual heating elements for total control (1000 watts and 500 watts)
Stainless steel 1/2 in ball valve for draining (don't have to use the pump)
Immersion wort chiller included
Stainless steel malt pipe/basket
Stamped volume markers
Magnetic drive pump for recirculation
32.75 in H (with recirculation arm) x 12.5 in Dia